Whiteline MK7/8V Golf/GTI/R A3/S3 Roll Centre / Bump Steer Correction Kit

IMPORTANT NOTES - Reduces roll/bump steer - essential for lowered cars.

A must for lowered vehicles, Whiteline roll center and camber adjusting correction kit, is designed to correct roll-center geometry using specially engineered ball-joints, whilst at the same time allowing fine tuning of camber settings with up to ½ a degree of negative camber gain, perfect for track days and spirited driving!

Raising the front roll-center (along with negative camber) results in a substantial increase to front roll resistance and a significant reduction in suspension compression on the outside front tire during cornering. The result is more even weight distribution and improved tire contact ultimately improving front end grip, cornering speeds and tire life when driving the vehicle to it’s potential.

Installation Guide: Download Now

Installation Time (hours): 2

Difficulty: Trade Specialist

Wheel Alignment Required? Yes

Lubrication Guide

In the majority of applications the Whiteline bushings act as a flexible bearing and must be greased at the time of assembly.To gain optimum performance from Whiteline products take the following precautions when installing:

Ensure all suspension parts are free from rust, scale, paint and previous rubber deposits.

Please use these hints along with any instructions provided when fitting Whiteline products. Vehicle manufacturers manual should be used to ensure Whiteline warranty compliance.

Shackle and mounting pins, control arm and spring eyes and shoulders must show no major signs of pitting or damage - any damaged components must be replaced or repaired to vehicle manufacturers tolerances.

Grease has been supplied in the kits where required and must be used to optimise bush performance and durability. Grease has been formulated from a reinforced No. 2 lithium complex base and selected additives with molybdenum disulphide for mechanical stability, extreme pressure qualities for extended life and a high melting or drop point be applied to the bores and outer flanges of all bushes and components - do not grease the outside surfaces of bushes and components.

NOTE:

The major noise producing factor in polyurethane is incorrect fitment and uncleaned mating surfaces.