Step 1: Remove Factory Shift Knob, and push the Euro Impulse adapter all the way up, until the threads are coming out.

Step 2, use your finger to push and force  the end of the boot, down to the bottom of the threads, where most of the threads are showing, and there is no leather blocking the threads, just as shown in the picture.

Step 2, use your finger to push and force  the end of the boot, down to the bottom of the threads, where most of the threads are showing, and there is no leather blocking the threads, just as shown in the picture.

Step 3: Screw on the shift knob onto the adapter., and make sure that the boot is clear of the threads, so that there is no unusual gap between the adapter and the knob.

Step 4: Make sure that you have the Logo, and the Shift boot & trim aligned, so that when you clamp it on, the logo will not be off center. If you need to adjust it, twist the knob and the adapter until you align the logo correctly. because after this step, there is no more adjusting or twisting or logo position. 

Step 5: push the adapter out of the opposite side of the shift boot, where you can clearly work with the adapter with no issues. just like in the image above.

Step 5: push the adapter out of the opposite side of the shift boot, where you can clearly work with the adapter with no issues. just like in the image above.

Step 6: slide the knob on to the shifter rod, and adjust it to your preferred height you would like to keep it at,  NOTICE!: *WE RECOMMEND YOU USE YOUR OWN ALLEN KEY RATHER THAN THE ONE PROVIDED WITH YOUR PRODUCT*, SINCE PEOPLE TEND TO OVER TIGHTEN WITH THE SCREWS AND STRIP THEM WITH THE KEY THAT WE PROVIDE). Then, take the allen key, and tighten each screw EVENLY, as in turn each screw with the allen key only a quarter turn each screw until it is tight on the rod. AVOID tightening the screws all the way separately. take turns tightening each screw a quarter turn until it is tight enough.

Step 6: slide the knob on to the shifter rod, and adjust it to your preferred height you would like to keep it at,  NOTICE!: *WE RECOMMEND YOU USE YOUR OWN ALLEN KEY RATHER THAN THE ONE PROVIDED WITH YOUR PRODUCT*, SINCE PEOPLE TEND TO OVER TIGHTEN WITH THE SCREWS AND STRIP THEM WITH THE KEY THAT WE PROVIDE). Then, take the allen key, and tighten each screw EVENLY, as in turn each screw with the allen key only a quarter turn each screw until it is tight on the rod. AVOID tightening the screws all the way separately. take turns tightening each screw a quarter turn until it is tight enough.

Step 7: After tightening the screws, clip the boot trim back into place. The picture above shows how the final image should look.: Clean, Flush, and Tight.

Step 7: After tightening the screws, clip the boot trim back into place. The picture above shows how the final image should look.: Clean, Flush, and Tight.