955/957: CAYENNE TUBULAR REAR TIRE SWING OUT BUMPER (2004-2010)

EWORREARSWINGB956

Built to Order: Usually Ships in 9 to 13 Weeks

DISCLAIMER: This is a built to order product. Built to order items may not be cancelled after 72 hours from the time of purchase, as they are then placed in the fabrication queue. No returns accepted on these products, without exception.

- - - 

Eurowise's solution to a full size spare tire with built in accessories. This is a complete rear bumper replacement built from Steel tubular construction with modular dual rear swing out system built in! Little to no trimming needed for installation. It is entirely up to the user to decide on trimming lower bumper plastic or not. It does however have more of a flush and appearance if trimmed.

The tubular rear bumper with built in heavy duty hitch. We've overbuilt these rear bumpers for optimum strength and added approach angle. We raised the rear hitch mounting point 4 inches. The square tubing support bar is 1/4 inch thick wall tubing. The recovery point support tubing is welded thru the inside of the square tubing and then welded to the 3/8 thick mounting plate for extra strength.

Your OEM exhaust will need to be cut off and new exhaust tips will need to be fabricated to raise the exhaust system to match the new bumper. We plan to have a DIY weld on exhaust rear tip soon. This bumper takes place of the rear lower portion of the bumper so you will need to remove that section of the rear bumper as well. Rear hitch is compatible with Eurowise rear swing out tire carrier. The hitch on this bumper has also been tested up to 8500lbs.

The Dual swing out portion houses a full size spare up to 35" tire size (larger may fit). The passenger side swing out comes bare with no options. Please select from Ala Carte menu items for a combination of accessory mounting brackets to use with your swing out. Not all combinations can be used.

ACCESSORY OPTIONS ADDING:

Dual Fuel Can/High Lift Jack Mount or Water/Fuel Can Mount/High Lift Jack Mount

Your swing out layout may differ from the photos below. 

If you have a factory hitch installed please add hardware. The OEM hitch hardware will be too long.

REMOVAL OF REAR MUFFLER IS REQUIRED FOR THIS BUMPER TO FIT
REAR RECOVERY POINTS ARE NOW WELDED TO THE MAIN SQUARE TUBE NOT THE ROUND TUBE AS PICTURED FOR OPTIMUM STRENGTH. 

Offroad Build Gallery: Click Here